What You Will Need
1. Elastic (no wider than 1")
2. 4 Straight Pins
3. Needle and Thread
4. One 1" Metal Back Patch
5. 1 Garment Tape Measure
7. Four 1" Grips With Brackets
STEP 1: With the tape measure, measure from 1 inch below your left front pant loop, bring the tape measure over your left shoulder and down to 1 inch below and to the right of your center pant loop, or 1 inch below your right back pant loop. This is the length of elastic you will need. Be sure to cut 2 strips of the elastic in this length.
STEP 2: With the scissors, cut 2 straps from the elastic in the length you measured in step 1.
STEP 3: Use the straight pins to pin a horizontal line to hold the elastic end around the grip, making sure that when the grips are clipped onto your
pants, the elastic is snug but comfortable.
STEP 4: Hand sew the end of the elastic so that it's around one of the grip ends. (This will be the back right end)
STEP 5: Take the end of the elastic that is not yet sewn, and put it through the metal back patch, so that the point of the triangle is facing up.
STEP 6: Sew the unfinished side so that it's around a second grip end.
STEP 7: Take the second strap of elastic and repeat steps 3-5, making sure both straps of elastic form an overlapping X.
STEP 8: Trim off most of the excess elastic that remains, clip on all 4 grips.